Oligoglycine Appendix

Gly1
    Structure (a) in the figure at right corresponds to the most stable conformer of GlyH+ obtained by DFT calculations using a B3LYP/6-311G** basis set. The dihedral angle α is 0° [see depiction in (b)], but rotation about the C-N axis does not appear to be severely hindered, since the conformation with α=60° is only 1 kcal/mol higher in energy. For GlyNa+ two structures are possible, one with the sodium ion bound to neutral glycine in its amino acid form [structure (c)], and one with Na+ bound to zwitterionic glycine [structure (d)]. A full geometry optimization on a MP2/6-311++G** level indicates, that the first form (c) is some 3.6 kcal/mol more stable than the second one (d) after zero point energy correction. The much faster DFT B3LYP/6-311++G**calculation agrees with the MP2 result within 0.3 kcal/mol. The structures found by molecular modeling are with minor deviations the same as the ab initio conformations. The single minima located for GlyH+ (α=60°) and GlyNa+ (zwitterion; α=0°) correspond to the structures shown above. For Na+ bound to Gly in its amino acid form three minima were found, the lowest one being that shown in structure (c) above.

Gly2
    Molecular mechanics calculations indicate that diglycine ionized at the N-terminus, Gly2H+ [structure (a) in figure at right] and Gly2Na+ [structure (b)], prefer a cyclic arrangement as depicted for structure (a). The corresponding extended linear conformations are ~7 kcal/mol higher in energy. Note, that the dihedral angle ω along the peptide bond, which usually is ~180° ("trans") in any oligoglycine or other peptide systems, is ~0° ("cis") for the lowest-energy conformers in both of these dimer systems. In this arrangement the protonated N-terminus can be better solvated by the C-terminal oxygen. The sodiated glycine form (c) is determined by the solvation of Na+ by the two >C=O groups. The terminal -NH2 is either also bound to Na+ or forms a hydrogen bond with the amide hydrogen as shown in (c), the latter structure being ~1.5 kcal/mol more stable. DFT calculations on Gly2Na+ indicate at all levels of theory, that form (c) is more stable by more than 10 kcal/mol than form (b).

GlynH+, n=3-6
    Semiempirical geometry optimizations carried out on structures obtained from molecular mechanics calculations for Gly4H+ and Gly5H+ indicate that salt bridge structures of the form I are substantially less stable than simple charge solvation structures of type II.

Thus, for energetic reasons protonated oligoglycines of the form I can be excluded as possible candidate structures not only for the small Gly2H+ and Gly3H+, but also when the chain is long enough to allow separation of the two positive charges and formation of a salt bridge between the positive N-terminus and the negative C-terminus. Molecular mechanics results indicate that protonated oligoglycines prefer a cyclic arrangement where one of the N-terminal amino hydrogens forms a hydrogen bond to the C-terminal >C=O group (see figure below). Some of the amide >C=O groups are also bound to the N-terminus to help solvate the charge. The lowest-energy conformers are held together by three such H-bonds, which fold the peptide into a pretty spherical shape. More extended conformers are typically higher in energy and there is a reasonable correlation between the energy of a conformation and its calculated cross section or degree of unfolding.

GlynNa+, n=3-6
    The GlynNa+ structures (where Glyn is a non-zwitterion) obtained by molecular mechanics are determined by the solvation of Na+ by >C=O. Even for the hexamer, all >C=O groups can coordinate around the Na+ ion, but the lowest-energy conformers (for n=4-6) have 4 to 5 such electrostatic O-Na bonds. This is still a large coordination number and combined with the rather long O-Na bonds of 2.3 to 2.5 Å, it causes the relatively small peptide to unfold and span around Na+ like an open umbrella, resulting in a quite oblate shape (see figure below).

    The conformers of zwitterionic oligoglycine bound to Na+ are all fairly compact. In all cases we were able to locate only a small number of different conformers using our simulated annealing procedure, and in all cases there exists one particularly stable conformation, shown in the figure below for Gly5Na+. All of those "salt bridge" conformers have in common that both Na+ and -NH3+ are bound to the carboxylate group via an electrostatic bond and 1 or 2 H-bonds, respectively. The amide >C=O groups coordinate either to Na+ or to -NH3+. The coordination number for Na+ is typically 4 (3 for n=3), and
-NH3+ forms between 2 (for n=3,4) to 3 (for n=6) hydrogen bonds.